Fitting The Upper Belt Guard (When Using Clutch Motors); Fitting The Lower Belt Guard (When Using Clutch Motors) - Pfaff 333-712/02 Instruction Manual

8 Fitting the upper belt guard
.01.06
4
5
Fig. 8 - 05
8 Fitting the lower belt guard
.01.07
Fig. 8 - 07
Installation and commissioning
(when using clutch motors)
1
3
2
6
(when using clutch motors)
1
If a large balance wheel is
used, the corner 1 of the belt
guard 3 must be broken out.
● Screw stop piece 2 onto belt guard part 3.
● Screw on belt guard part
housing.
● Screw on belt guard part
housing.
● Secure belt guard parts
table top.
● Position belt guard 1 so that motor pulley
and v-belt can run freely.
Fig. 8-07 shows a motor.
If a different motor is used,
please refer to the instruction
manual of the motor manufac-
turer.
3 onto the
4 onto the
5 and 6 onto the
19