Olivetti d-Copia 12 Service Manual page 60

Main code Sub code
25 01
10
26 01
02
03
6-6
Main motor system ON + Cooling fan low speed
(Operation/Procedure)
When the START key is pressed, the main motor is rotated for 30 sec.
To save toner consumption, the different operations are executed depending on
installation of the developing unit.
• When the developing unit is installed, the developing bias, the main charger, and the
grid are also outputted.
• When the developing unit is not installed, only the motor is rotated.
* Do not turn on the door open/close switch forcibly to execute this simulation.
Polygon motor ON
(Operation/Procedure)
When the START key is pressed, the polygon motor is operated for 30sec.
Manual feed setup
(Operation/Procedure)
1. When this simulation is executed, the currently set bypass code number is displayed.
2. Enter the code number corresponding to the bypass and press the START key, and
the setting will bechanged.
Code number
0
1
SPF setup
When this simulation is executed, the currently set SPF code number is
displayed. Enter the code number of the SPF to be set and press the PRINT switch. The
setup is changed.
Code number
0
1
2
Second cassette setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the second
cassette is displayed.
2. Enter the code number and press the Start key. The setting is changed.
Code number
0
1
Service Manual
Content
Bypass
Single bypass
Multi bypass
SPF
Without SPF
With SPF (Setup required
when installing FAX)
With RSPF
Second cassette
Without second cassette
With second cassette
Y101700-5