Operation Panel Section; Charger Wire Replacement - Olivetti d-Copia 12 Service Manual

(2) Set the charger cleaner to the transfer unit, and move it
reciprocally a few times in the arrow direction shown in
the figure below.

4.1.6 Charger wire replacement

(1) Remove the TC cover and remove the screw.
(2) Remove the spring and remove the charger wire.
(3) Install a new charger wire by reversing the procedures
(1) and (2).
At that time, be careful of the following items.
• The rest of the charger wire must be within 1.5mm.
• The spring hook section (charger wire winding section)
must be in the range of the projection section.
• Be careful not to twist the charger wire.
4-4

4.2 Operation panel section

4.2.1 List of parts
No.
1
2
4.2.2 Disassembly procedure
(1) Remove the screws (4 pcs.), the harness, and the
operation panel unit.
(2) Remove the screws (3 pcs.) and the PWB holder.
(3) Remove the screws (3 pcs.) and the operation PWB.
Service Manual
Part name Ref.
Operation panel unit
Operation PWB
Y101700-5