Loading Sheet Material - Roland FJ-500 User Manual

Loading Sheet Material

Remove the left-hand media flange at the back of the
1
unit.
Move the right-hand media flange at the back of the unit
to a position where it does not touch the loaded material.
Pass the material between the pinch rollers and the grit
2
rollers.
3 Line up the right-hand side of the material with the
guide line, and line up the front edge of the material
with the reflective tape.
If the front edge of the material has been cut at an
angle, pull out the material so that all of the material
covers the reflective tape.
* Be sure to line up the right-hand edge of the material
with the guide line.
If the material is not positioned correctly when you
press the [SETUP] key, the message "SET AGAIN"
appears on the display.
Drape the pulled-out portion at the back between the
4
unit and the media guide.
Move the sheet loading lever toward LOAD.
5
The pinch rollers lower to hold the material in place.
Close the front cover, and press the [SETUP] key.
6
This detects the width of the material and displays the
printable width.
Front
Sheet material
Front
Material
Media guide
The SETUP LED lights up
Top menu
W 300 mm
NORMAL
2 Basic Operation
Guide line
Reflective tape
Sheet loading lever
BI-DIR
23