Test Printing - Roland FJ-500 User Manual

2-4 Test Printing

Before starting to print, carry out a Test print to check the state of the head.
Problems such as missing dots may reduce the printing quality.
If the test results show a problem, carry out head cleaning to restore the head to its normal state.
1 Load a material, then close the front cover.
2 Press the [CLEANING] key to execute [TEST PRINT].
Direction of material
discharge
If there are any missing dots or other evidence
of a drop in printing quality, clean the head.
For more information about head cleaning, see
"3-3 Cleaning the Printing Heads."
If there is dot drop-out on
this side, then for
[CLEANING], choose
[LEFT HEAD].
If there is dot drop-out in both areas, then for
[CLEANING], choose [BOTH HEADS].
Press the [ENTER] key to
CLEANING
print a test pattern.
TEST PRINT
If there is dot drop-out on this side,
then for [CLEANING], choose
[RIGHT HEAD].
2 Basic Operation
25