User's Reference; Materials; Conditions For Usable Materials; Acceptable Material Widths - Roland FJ-500 User Manual

4-1 Materials

* Use genuine media for the FJ-500/400.

Conditions for Usable Materials

A) Maximum material thickness
B) Maximum diameter for roll material : 180 mm (7-1/16 in.) (Surface to be
C) Core inner diameter for roll material: 50.8 mm or 76.2 mm (2 in. or 3 in.)
D) Maximum weight for roll material
E) Roll material that is not taped down to the paper tube

Acceptable Material Widths

FJ-500
210 to 1371 mm (8-5/16 to 54 in.)

4-2 Adjusting the Height of the Printing Head

When using material that is thick or susceptible to warping, material feed may not proceed smoothly, or the material may jam. When
such material is loaded, you can adjust the height of the printing head.
This should normally be left at position 1 (low). If printing results in material feed that is not smooth because of problems such as the
material jamming or the head catching on the material, position at 2 (high).
When the height of the printing head has been adjusted, it is necessary to perform bidirectional correction (only when the printing
direction for [PRINT QUALITY] has been set to [BI-DIRECTION]). For more information about bidirectional correction, see "2-5
Printing - Making Corrections for Printing - Bidirectional Correction."
Height of the printing head
High
2
1
Low

4 User's Reference

: 1.0 mm (0.039 in.) (When head is raised)
printed must face outward)
: 20 kg (44.1 lb.)
FJ-400
210 to 1117 mm (8-5/16 to 44 in.)
Lever
1
4 User's Reference
Side view of roll material
2
63