What To Do If - Roland FJ-500 User Manual

4 User's Reference

4-7 What to Do If...

What to Do If...
If the FJ-500/400 doesn't run...
Is the power cord connected correctly?
Connect the power cord included with the FJ-500/400 to the unit, and plug the other end securely into an electrical outlet. (See "1-2
Making the Connections" .)
Is the FJ-500/400 power on?
Turn on the power. (See "2-2 Powerup" .)
Has material been loaded (the SETUP LED is lit)?
If the SETUP LED is not illuminated, make sure the material is loaded correctly and press the [SETUP] key to illuminate the SETUP
LED.
Is the PAUSE LED illuminated?
If the [PAUSE] key has been pressed and the PAUSE LED is lighted, the unit has been paused.
To resume printing, press the [PAUSE] key again. The PAUSE LED is extinguished, and printing resumes.
To terminate printing, first stop the transmission of printing instructions from the computer to the FJ-500/400. Then press the [SETUP]
key. Hold down for about 1 second. This deletes the printing instructions that have already been sent from the computer to the FJ-500/
400, and printing is stopped.
Is the top menu displayed?
If the top menu isn't displayed, printing doesn't start even when data is sent from the computer.
Conditions for starting printing
The material must be already set up (with the SETUP LED lighted),
and the display must show the top menu.
If another menu screen is displayed, press the [SETUP] key to go back to the top menu.
(Pressing the [SETUP] key when another menu screen is displayed does not cancel the set-up for the material.)
Are the computer and the FJ-500/400 linked with the right cable ?
The type of cable you need is determined by your computer. One which you are sure matches the model of computer being used should
be select.
Is the cable making a secure connection?
Connect securely. (See "1-2 Making the Connections" .)
Has the correct driver selection been made for the application software?
Select the appropriate FJ-500/400 driver.
82
Top menu
W 1234 mm
NORMAL BI-DIR