Panasonic KX-VC300 User Manual page 48

Starting a Video Conference
Operating an MCU Remotely using Tone Signals
When connecting to an MCU, you can send tone signals by pressing buttons (0–9, #, or
control. Doing so allows you to operate (e.g., change the screen layout) the MCU remotely.
Note
•
Tone signals can only be sent when connecting to an
MCU. They cannot be sent between Panasonic HD
Visual Communication Units.
•
Features and operations that can be performed
remotely will vary depending on the MCU.
•
If the MCU you are connecting to does not support
tone signals, an error message is displayed.
•
If the other party sends tone signals to you, sound
may be interrupted or a ringing noise may occur.
1 Enter a tone signal (0–9, #, or
•
The input field (A) is displayed.
A
Note
•
The input field can only contain up to 16
characters. If you input 17 characters, the first
character input will not be displayed in the input
field but all tone signals will be sent.
•
The input field is not displayed until a tone signal
is entered.
•
If a tone signal is not entered for about 3
seconds, the input field disappears.
•
If you enter further tone signals after the input
field has disappeared, the tone signals entered
the previous time are also displayed.
48 User Manual
).
1
) on the remote