Konica Minolta 7020 Service Manual page 195

HOME
No. Menu
2 Timing adjustment
3 Running mode
4 Test pattern print
5 Density adjustment
6 Copy quality adjustment
No. Sub menu
5 Centering
adjustment
3
6 Image read point
adjustment
7 Restoring standard
data
1 Intermittent copy
mode
2 No paper intermittent
copy mode
3 No paper mode
4 No paper endless
mode
5 Running mode
— None
— Test pattern density
adjustment
1 RADF scanner
density adjustment
2 Non-original erasure
3
installation survey
Circular menu
Centering adjustment (ADU, common)
Centering adjustment (ADU, small size)
Centering adjustment (ADU, large size)
Centering adjustment (By-pass, common)
Centering adjustment (By-pass, small size)
Centering adjustment (By-pass, large size)
Centering adjustment (Platen)
Centering adjustment (RADF single side)
Centering adjustment (RADF double side (first side))
Centering adjustment (RADF double side (second side))
Planten adjustment
Vertical/Horizontal magnification adjustment
Restart timing adjustment
Paper feed loop amount adjustment
Leading edge original erasure adjustment
Centering adjustment
Image read point adjustment
None
None
None
None
None
4-37
36
ADJUSTMENT
Summary of operation
Print the SGU patters (No.16) after making
an adjustment.
After making an adjustment, make a copy.
The same as 36 mode 9 RADF Adjustment.
After making an adjustment, make a copy.
Reset the adjustment data in the same
condition as they were when the machine
left the factory.
After making a selection, carry out operation.
Print the SGU pattern according to the
specification No.
After making an adjustment, print
the specified SGU pattern.
Make a density adjustment by letting the
machine read white chart.
Check with RADF opened completely.
(Other than 7020/25/30)