Power Management - Juniper Archer 2 Owner's Manual

Disabling and Enabling the Touchscreen
You can disable the touchscreen. This is useful when you
are running an application and you want to see the screen
while avoiding accidental touchscreen activation. The
touchscreen can also be disabled for cleaning purposes.
1. Press the shift
touchscreen on and off.
2. Press and hold the power button
Power Button menu. Select Disable TS. (You must use
option 1 above to enable the touchscreen.)
When the touchscreen is disabled, this icon
title bar until the touchscreen is enabled again.

Power Management

The Archer 2 uses a Li-Ion rechargeable battery pack.
!
CAUTION: Only use batteries designed for the Archer 2 from
an approved vendor. Use of non-approved batteries may
void your product warranty.
Charging the Battery Pack
To charge the battery pack, suspend the handheld, then
refer to the instructions in Chapter 1, Getting Started. It
typically takes 4 to 5 hours to fully charge a battery pack.
We recommend that you keep the handheld battery pack
charging when it is not in use for up to two weeks. When you
plug the handheld into the wall charger that comes with it,
the batteries are prevented from being overcharged.
The Li-Ion battery pack is charged most efficiently at
room temperature (68°F or 20°C). The battery pack will not
charge if it is too hot or too cold.
!
CAUTION: The Archer 2 is not sealed against water and dust
when the battery door is not installed properly.
+ backspace
Ch 2 Hardware Components
buttons to toggle the
to bring up the
is shown in the
21