Sd Cards - Juniper Archer 2 Owner's Manual

SD Cards

The Archer 2 has a slot for a micro SD card located in the
battery compartment. To insert or remove a card follow
these steps:
1. Power off the handheld.
2. Loosen the screws to the battery compartment and
remove the door (the hand strap remains attached).
!
CAUTION: The Archer 2 is not sealed against water and
dust when the battery door is not installed properly.
3. Remove the battery pack.
4. An image on the battery compartment label shows the
correct location and orientation for the SD card (slot
on the right). Push the card into the slot to insert it. To
remove the SD card, pull it out.
5. Replace the battery pack and attach the battery door.
6. Power up the handheld.
Ch 2 Hardware Components
25