Table of Contents
Advertisement
3. Place the Li-Ion battery pack in the compartment.
Make sure the symbols on the battery pack label align
with the symbols inside the compartment.
4. Replace the door and tighten the screws.
5. Plug the AC wall power charger that came with the
Archer 2 into a wall socket. Plug the other end into the
DC power jack on the Archer 2. The red LED on the
keypad blinks when the battery pack is charging.
Line the symbols up
on the case and the
battery pack as shown
Ch 1 Getting Started
5
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Juniper Archer 2
Related Products for Juniper Archer 2
- Juniper Archer
- Juniper Archer 3
- Juniper 200 Series
- Juniper ADVANCED INSIGHT SCRIPTS 2.5 - S REV 1
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1