Table of Contents
Advertisement
dust when the battery door is not installed.
4. An image on the battery compartment label shows the
correct location and orientation for the mini SIM card.
Pull out the SIM card tray. Place the card onto the tray
and push the tray in until it catches.
To remove the mini SIM card, pull the tray open and
remove the card. Push the empty tray in until it catches.
5. Replace the battery pack and attach the battery door.
6. Power on the Archer 2.
Note: If the modem was on before shutting the Archer 2
down to insert the mini SIM card, you are prompted to
configure the data connection when you reboot. See
the instructions on the following pages.
Ch 8 3G Data Modem
73
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Juniper Archer 2
Related Products for Juniper Archer 2
- Juniper Archer
- Juniper Archer 3
- Juniper 200 Series
- Juniper ADVANCED INSIGHT SCRIPTS 2.5 - S REV 1
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1