Salus VS20WRF User Manual page 4

iT600 VS20W - Installer - User Manual 011_Layout 1 07.07.2014 10:35 Stron
Product Compliance & Safety Information
These instructions are applicable to the SALUS
model stated on the front cover of this manual only.
Warning
This product must be fitted by a competent person,
and installation must comply with the guidance,
standards and regulations applicable to the city,
country or state where the product is installed.
Failure to comply with the requirements of the
relevant guidance, standards and regulations could
lead to injury, death or prosecution.
Sources of danger
The thermostat must be disconnected from mains
supply before removing the cover.
Emergency
Switch off the voltage to the individual thermostat
wring centre or complete system.
04
VS20WRF and VS20BRF Installer Manual
230V AC
Warning
Always isolate the AC Mains supply before
installing or working on any components that
require 230 VAC 50Hz supply.
Installer parameter settings
The SALUS VS10 and VS20 are equipped with
installer parameter section (see page 57) this
must only be entered by the installer or
competent person. Changing
parameters can have a serious effect on your
heating system
For the installer
Please enter any parameter changes in the
installer notes section (pages 90)
these