Installation – System Parameters - Salus VS20WRF User Manual

iT600 VS20W - Installer - User Manual 011_Layout 1 07.07.2014 10:36 Stron
Installation – System Parameters
You are now ready to configure the unit
using the system parameter table below.
SX
SO1
S02
*Grouping is available on the wiring centre only please refer to page 6. Additionally you
must have a PRT per group for grouping to operate. Two groups are the maximum
allowed per wiring centre.
** This setting is used when there is a system receiver only in the system. If there is a system
receiver set to RX1 used along with wiring centre, radiator valves and system receiver set to RX2
then RX1 will communicate automatically to the thermostat connected to these other devices.
FUNCTION SYSTEM SETTING
System Unit 0
Type 1
2
What does unit 0*
Communicate 1
within the iT600 2
system 3**
DEFINITION
Programmable Stat (PRT)
Digital Thermostat
HW Timer
It600 Wiring Centre*
It600 radiator valve
System Receiver set for RX2
System Receiver set to RX1**
VS20WRF and VS20BRF Installer Manual
DEFAULT
0
0
31