Sd Card Installation - Zoom R8 Operation Manual

SD card installation

The saves recording data and settings on SD cards.
To protect your data, turn the power off before inserting or ejecting a card.
An SD card is necessary for recording.
Turn the power OFF and insert (ordinary use)
1
Turn the POWER OFF and remove the
SD card slot cover.
2
Insert an SD card that is not write-
protected into the slot completely.
To eject, push the card in first.
Preventing SD card theft
Remove the screw near the slot, and
screw it into the hole in the SD card
cover.
Unlock write-protection
NOTE
If you want to change the SD card while the
power is ON, you must follow special procedures.
(P.110)
When inserting or removing an SD card, always
turn the power OFF. Doing so when the power is
ON could cause recording data to be lost.
If you cannot insert a card into the slot, you
might be trying to insert it in the wrong direction
or upside down. Do not force the card. Try again
with the correct orientation. Forcing the card in
could break it.
Always format an SD card that was used with a
computer or a digital camera, for example, in the
before using it.
If no SD card is inserted, the
function in Recorder Mode.
If a message appears
"No Card": No SD card is detected. Make sure an
SD card is inserted properly
"Card Protected": The SD card is write-protected.
Slide the lock switch away from the lock position
to disable write-protection.
HINT
This unit can use 16 MB–2 GB SD cards and
4–32 GB SDHC cards.
You can ind the most recent information about
compatible SD cards on the ZOOM website.
http://www.zoom.co.jp
☞
Reference:
Changing SD cards with the power on
Formatting SD cards
REC
key will not
P.110
P.111
13