Locating To The Desired Part Of A Song - Zoom R8 Operation Manual

Locating to the desired part of a song

The counter on the display can be used to move (locate) to the desired time in hours: minutes:
seconds: milliseconds or bars–beats–ticks (1/48 beat).
You can also set marks in a project to locate to them easily.
Using the counter to locate
To prepare, stop the recorder, select the
project and start from the Top Screen.
1 Select the hours: minutes: seconds or
bars–beats–ticks.
Hours: minutes: seconds: milliseconds"
or "Bars–beats–ticks"
2 Change the values.
NOTE
● You cannot change the counter this way
during recording or playback.
HINT
● After Step 2, you can start playback from
the set counter position.
● Mark icon display
● Mark zero
(project beginning) and cannot be changed.
● If you add a mark at a time earlier than an
existing mark, all the following marks will be
automatically renumbered in order.
● One project can have a maximum of 100
marks, including the zero mark.
36
Change unit/digit
Change display
Change numbers
is always set at counter 0
Mark 03 shown set at 10 minutes,
08 seconds, 15 milliseconds
Mark set at current
counter position
No mark set at counter
position
Adding marks
Add a mark using the counter
1
Start from the top screen. Set the
counter to the desired mark position.
2
Press
Adding a mark during recording/playback
1
Start recording or playback
2
Press
Change unit/digit
Change display
Mark icon
Mark number