Nikon Eclipse Ni-E Instruction Manual page 29

2 Attach the stage
(1) Remove the motorized XY stage cover fixing screws
(x4) using a hex driver and remove the cover.
(2) Align the attachment holes inside the stage with the
screw holes on the substage to place the stage.
(3) Tighten the four hexagon socket head bolts (M4 x2,
M5 x2) provided with the stage and secure the
stage.
(4) Attach the cover removed in step (1).
3 Connect the cable
(1) Using the microscope connection cable, connect the
MICROSCOPE connecter of the TI-S-CON
motorized XY stage controller to the STAGE
connector of the connector box at the rear of Ni-E.
(2) Using the driver cable, connect the motorized XY
stage to the DRIVE connector of the stage controller.
Motorized XY stage controller fuse
The motorized XY stage controller will not operate if
its fuse is blown. Replace the fuse in accordance with
the following procedure.
Chapter 1
Assembly
(The front two holes are not
used in the Ni-E focusing stage
system.)
Hexagon socket head bolts (M4)
21
Motorized XY stage cover
Removing the cover
Hexagon socket head bolts (M5)
Securing the motorized XY stage
Connector box
STAGE
CONTACT ARM2 EPI SHUTTER
USB
MODEL ECLIPSE Ni-E
NIKON CORPORATION
9 1 0 0 0 1
TOKYO, JAPAN
M A D E I N J A P A N
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est confirme à la norme NMB-003 du Canada.
DSC1
CAUTION!
-High Temperature-
HGFIE 1. Do not touch the lamphouse while the lamp is lit.
The surface of the lamphouse becomes hot when the
lamp is on.
2. Turn off the power and allow the lamp and lamohouse
to cool enough before replacing the lamp.
Wait for at least 30 minutes after turning off the
BOX lamp.
3. Use 12V100W HALOGEN lamp only.
HALOGEN 12V100W
NI-LH
JAPAN
9 5 2 0 0 1
Motorized XY stage
Stage and stage controller connection
MICROSCOPE
DRIVE
MADE IN JAPAN
TI-S-CON
100-240V~ 2A 50/60Hz
NO. 5 6 1 0 0 1
This device complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference,and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
AC IN
100-240V ~
2A 50/60Hz
Motorized XY
stage controller