Protocol Settings; Tcp/Ip - Sharp MX-4140N Operation Manual

USER'S MANUAL - SETTING MODE

PROTOCOL SETTINGS

Select the general network settings.
The TCP/IP, NetWare, EtherTalk, and NetBIOS status information can
be set.

TCP/IP

TCP/IP Settings
TCP/IP
To use the machine on a TCP/IP network, this setting must be enabled.
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting
to configure the IP address of the machine.
DHCP/BOOTP
Use this setting to have the IP address obtained automatically using
DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap
Protocol). When this setting is enabled, it is not necessary to manually
enter an IP address.
I f D H C P / B O O T P i s u s e d , t h e I P a d d r e s s a s s i g n e d t o t h e m a c h i n e m a y
c h a n g e a u t o m a t i c a l l y . I f t h e I P a d d r e s s c h a n g e s , p r i n t i n g w i l l n o t b e
p o s s i b l e .
I f t h e m a c h i n e i s u s e d o n a T C P / I P n e t w o r k , b e s u r e t o e n a b l e t h e
" E n a b l e T C P / I P
RARP
Set this option to use the RARP protocol.
file://C:\Files\PM Files\COPIERS\CR3.5\Virgo II\Manuals downloaded from MFP\mx514...
" b e l o w .
Page 276 of 384
4/24/2014