Linkage Disassembly - Husqvarna TC 449 2011 I.E. Workshop Manual

11
9
11
9
2
9
8
6
4
9
1
8
Workshop Manual Ed. 03-2012
TC 449 2011/2012 I.E.
TE 449 - 511 2011/2012 I.E.
TXC 449 - 511 2011/2012 I.E.
SMR 449 2011 I.E.
SMR 511 2011/2012 I.E.
- Check bearings (11), seals and bushings for wear.
H006191
- Upon reassembly, tighten nut (8) to 80 Nm - 8 Kgm - 59.00 ft-lb and pins (9)
to 100 Nm - 10 Kgm - 73.76 ft-lb.
10

Linkage disassembly

To remove drag link (1) and drop link (2), proceed as follows:
- Using a 14 mm wrench, remove the screw (3) retaining shock absorber drop
link (2).
3
1
H006193
H006194 - Using a 17 mm wrench, remove nut (4) and remove pin (5) on the other side.
2
- Using a 14 mm wrench, remove nut (6) and screw (7) on the other side.
- Ensure that needle roller bearings (8) and bushes (9) are not worn and replace
them, if necessary.
8
9
7
8
9
5
REAR SUSPENSION
Grease the inner race of the bearings before refitting them.
Upon reassembly, grease both bearings and bushes and tighten nut (6)
to 73 Nm - 7.3 Kgm - 53.84 ft-lb and nut (4) to 80 Nm - 8.0 Kgm - 59.00
ft-lb.
J.8