Husqvarna TC 449 2011 I.E. Workshop Manual page 268

Workshop Manual Ed. 03-2012
FRONT SUSPENSION
TC 449 2011/2012 I.E.
TE 449 - 511 2011/2012 I.E.
TXC 449 - 511 2011/2012 I.E.
SMR 449 2011 I.E.
SMR 511 2011/2012 I.E.
• Push the pre- assembled pumping element ( 23 ) until it is in contact with the
stanchion tube ( 5 ).
• Tighten the bottom valve by hand.
• Insert the R5081AA tooling inside the fork leg in a way that you can block the
body rotation; to do so, the slot obtained at the tooling bottom edge must be
perfectly inserted into the body hexagon.
In the tooling upper part there are two opposite holes where you can
insert an axle to make blocking easier. However, the tooling must
2 3
not be rotated in any case, but only used to hold the fork leg inner
parts.
5
• Using a 21 mm tube wrench tighten the bottom valve ( 41 ) up to the required
torque (see Table 1 - Tightening Torques).
4 1
I.44