What You Can Process With The Fat Channel And Firewire Sends - PRESONUS StudioLive 24.4.2 Owner's Manual

Owner's Manual

What You Can Process with the Fat Channel and FireWire Sends.

4.1.2
Bus
Inputs (Ch 1-24)
Subgroups
Main Out L/R
Aux Sends 1-10
Internal FX Sends A & B
External FX Returns A & B
Tape Input
Talkback Mic
Solo Bus
Monitor Bus
Selected Channel Meters. In addition, two meters—part of a set of eight meters
located in the top right section of the mixer—are dedicated to displaying
information about the currently selected channel. The meter on the far left of this
section displays the pre-fader input level for the selected channel. The meter to the
right of it displays the gain reduction for the selected channel. It is important to
mention that these meters are only active when one of the 24 input channels or an
aux bus is selected.
It should be noted that while the noise gate, compressor, EQ, and limiter are
available on every input and bus, the high-pass filter is only available on the inputs,
10 auxes, and 2 internal FX buses, and the phase reverse is only available on the
24 inputs. In addition, other inputs and buses without Select buttons are available
to route to the auxiliary FireWire returns. (See Section 6.4.2 for more details.)
The following table provides a quick guide to the processing
that is available for each bus in the StudioLive:
Phase High-Pass Noise
Reverse Filter Gate
The Fat Channel
Compres- EQ Limiter
sor
Controls 4
4.1
FireWire
Send
23 23 23