Solo Bus - PRESONUS StudioLive 24.4.2 Owner's Manual

4 Controls
4.7 Master Section
4.7.4

Solo Bus

Cue Mix Volume
Control
PFL/AFL Toggle Button
SIP (Solo In Place)
On/Off Button
Power User Tip: When SIP is engaged, channel mutes will only apply to the Subgroup and Main
assignments. SIP does not mute input channels in Aux Send mixes. Because of this, you can use SIP
to dial in a mix in the Mains, without disturbing the musicians' last-minute rehearsal on stage.
46 46 46
The StudioLive features a Solo bus for flexible monitoring. In this way, you can
fine-tune a vocal compressor in your control-room monitors or headphones
while the rest of the band is warming up or audition an aux mix for more accurate
adjustments. For more information on using the Solo bus, please review Section 8.8.
Adjusts the Overall Volume of the Solo Bus.
This knob adjusts the overall level for the Solo bus.
Enables PFL Solo Mode.
The default setting for the Solo bus is After-Fader Listen (AFL); by pressing PFL,
Pre-Fader Listening is enabled. In either mode, pressing Solo on any channel or bus
routes that channel to the Solo bus and has no effect on the main or subgroup mixes.
PFL soloing is not available for the Subgroups. The Aux bus soloing is always PFL,
regardless of whether this mode is engaged.
Enables Solo In Place Mode.
SIP (Solo In Place), or "destructive soloing, " mutes every unsoloed channel on the
StudioLive. If one of the muted channels is routed to the mains or a subgroup, it will
be muted in those outputs. This also applies to soloed channels: The output routing
is still active. Note that while you can manually unmute a channel, this mode should
be used with extreme caution during a live performance. Only the input channels
can be placed into destructive soloing. The Subgroups and Aux buses are omitted
from SIP mode.
To enable SIP, press and hold the button until it illuminates red. This ensures
that you cannot enter into destructive Solo mode by accident.
PreSonus StudioLive 24.4.2
™