Table of Contents
Advertisement
2
Technical Reference > MEAP > Preparation for Using SMS > Device Settings
■ Device Settings
● Network configuration ( Activate Netowork Settings )
To support a MEAP-enabled iR device via network (SMS, etc.), set up the network setting on
the touch panel of the iR device (this setting is [ ON ] by default).
1) Press [ Setup ] button, select [ Network ] > [ Control Menu ] > [ HTTP ] and select [ On ].
Setup
Control Menu
Paper Source
Network
Network
Layout
Control Menu
NetWare Settings
Apple Talk
SNMPv.1 Settings
2) Select [ On ], and then press [ OK ] on the Control Panel.
3) Restart the machine.
CAUTION:
• The setting [ Use HTTP ] is not actually enabled/disabled until you have restarted the
device.
• You cannot make a connection through a proxy server. If a proxy server is in use,
enter the IP address of the MEAP device in the Exceptions field for the browser.
Open Internet Options dialog of Internet Explorer and select Connections tab, LAN
Settings button, Use a proxy server option, and Advanced button of Proxy server
group. Proxy Settings dialog will opens. The Exceptions field is in the dialog. As
network settings vary among environments, consult the network administrator.
• If Cookie and JavaScript are not enabled in the Web browser, you will not be able to
use SMS.
2
Technical Reference > MEAP > Preparation for Using SMS > Device Settings
TCP/IP Settings
RAW Print
IPP Print
HTTP
WSD
HTTP
Off
On
● Key Pair and Server Certificate when Using Encrypted SSL
Communication
To use SMS via SSL connection, it is required to specify a key pair and server certificate as
the key to be used.
When specifying the key pair and server certificate necessary for encrypted SSL
communication, perform the following procedure in remote UI.
Note:
•
Although Server Certificate is registered as standard on MFP, it is not registered in the
machine (SFP). Therefore, this procedure is necessary.
•
For detailed procedures of the Default Key setting, refer to [e-Manual > Security].
•
As for SMS, by setting a Default Key, encrypted SSL communication is always executed
regardless of the following setting: [Settings/Registration] > [Management Settings]
(Settings/Registration) > [MEAP Settings] > [SSL Settings]: ON/OFF.
Generating a key pair
1) From a PC on the same network as the device, use a web browser to access the remote
UI's portal page. Then, select [ Settings/Registration ] from the menu on the right side of
the screen.
URL to access: http://<device's IP address>:8000/
F-2-55
2-36
F-2-56
2-36
Advertisement
Table of Contents
