Ricoh B089 Service Manual page 672

BIT SWITCHES
Communication Switch 10
No FUNCTION
0 Memory transmission:
to Maximum number of dialing
7 attempts to the same
destination
Communication Switch 11 - Not used (do not change the settings.)
Communication Switch 12
No FUNCTION
0 Memory transmission: Interval
to between dialing attempts to the
7 same destination
Communication Switch 13 - Not used (do not change the settings.)
Communication Switch 14
No FUNCTION
0 Inch-to-mm conversion during
transmission
0: Disabled 1: Enabled
1-5 Not used
6 Available unit of resolution in
to which fax messages are
7 received
Bit 7 Bit 6
0 0
0 1
1 0
1 1
Communication Switch 15 - Not used (do not change the settings)
B576
01 - FE (Hex) times
01 - FF (Hex) minutes
0: In immediate transmission, data scanned in inch
format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data into
mm format.
1: The machine converts the scanned data or stored
data in the SAF memory to the format which was
specified in the set-up protocol (DIS/NSF) before
transmission.
Do not change the factory settings.
For the best performance, do not change the factory
settings.
Unit The setting determined by these bits is informed to
mm the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
inch
mm and inch
(default)
Not used
COMMENTS
COMMENTS
COMMENTS
3-32
SP No. 1-104-017
SP No. 1-104-019
SP No. 1-104-021
SM