Ricoh B089 Service Manual page 633

Code Meaning
0-15 The other terminal is not
capable of specific
functions.
0-16 CFR or FTT not detected
after modem training in
confidential or transfer mode
0-17 Communication was
interrupted by pressing the
Stop key.
0-20 Facsimile data not received
within 6 s of retraining
0-21 EOL signal (end-of-line)
from the other end not
received within 5 s of the
previous EOL signal
0-22
The signal from the other
end was interrupted for
more than the acceptable
modem carrier drop time
(default: 200 ms)
SM
Suggested Cause/Action
The other terminal is not capable of accepting the
following functions, or the other terminal's memory is
full.
• Confidential rx
• Transfer function
• SEP/SUB/PWD/SID
• Check the line connection.
• Check the FCU - NCU connectors.
• Replace the NCU or FCU.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have disconnected, or it may
be defective; try calling another machine.
• If the rx signal level is too low, there may be a
line problem.
Cross reference
• See error code 0-08.
If the Stop key was not pressed and this error keeps
occurring, replace the operation panel.
• Check the line connection.
• Check the FCU - NCU connectors.
• Replace the NCU or FCU.
• Check for line problems.
• Try calling another fax machine.
• Try adjusting the reconstruction time for the first
line and/or rx cable equalizer setting.
Cross reference
• Reconstruction time - G3 Switch 0A, bit 6
• Rx cable equalizer - G3 Switch 07 (PSTN)
• Check the connections between the FCU, NCU,
& line.
• Check for line noise or other line problems.
• Replace the NCU or FCU.
• The remote machine may be defective or may
have disconnected.
Cross reference
• Maximum interval between EOLs and between
ECM frames - G3 Bit Switch 0A, bit 4
• Check the line connection.
• Check the FCU - NCU connectors.
• Replace the NCU or FCU.
• Defective remote terminal.
• Check for line noise or other line problems.
• Try adjusting the acceptable modem carrier drop
time.
Cross reference
• Acceptable modem carrier drop time - G3 Switch
0A, bits 0 and 1
2-3
ERROR CODES
B576