Ricoh B089 Service Manual page 658

BIT SWITCHES
System Switch 1A
No FUNCTION
0 LS RX memory remaining
refresh value setting
to
7
System Switch 1B - Not used (do not change the settings)
System Switch 1C - Not used (do not change the settings)
System Switch 1D
No FUNCTION
0 RTI/CSI display
0: Disabled
1: Enabled
1-7 Not used
System Switch 1E
No FUNCTION
0 Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
1 Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
B576
Sets a value of 4K.
If the amount of memory remaining falls below 4K,
documents received in memory are printed to create
more space in memory.
Initial value: 0x80 (512K)
00-FF (0-1020 KB: Hex)
1: RTI/CSI is displayed on the top line of the LCD
panel during communication.
Do not change the settings.
This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the
report (e.g., no paper).
0: If the buffer memory of the communication records
for the Journal has become full, fax communications
will become impossible, to prevent overwriting the
communication records before the machine prints
them out.
1: If the buffer memory of the communication records
for the Journal is full, fax communications are still
possible. But the machine will overwrite the oldest
communication records.
Cross Reference
Automatic Journal output - User switch 03 bit 7
!
Number of communication records for the
!
Journal:
200 records (standard)
1000 records (with the Function Upgrade unit
installed)
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
3-18
SP No. 1-101-026
COMMENTS
SP No. 1-101-030
COMMENTS
SP No. 1-101-031
COMMENTS
SM