Connecting To More Than One Sensor; Setting The Sensors To Connect - Omron FQ2-S/CH Series User Manual

7-5 Connecting to More Than One Sensor

FQ2-S1 FQ2-S2 FQ2-S3
Up to eight sensors can be connected to one Touch Finder or a computer used for PC Tool.
This sections describes how to connect more than one Sensor to a Touch Finder or computer.

Setting the Sensors to Connect

Use the following setting to connect more than one Sensor to a Touch Finder.
Automatically Connecting Sensors
The Touch Finder can detect Sensors and automatically connect to them in the order that it detects them.
The Touch Finder can detect up to 32 Sensors and it can connect to up to eight Sensors at the same time.
Set this parameter to [OFF] to connect to only a specific Sensor.
(Setup Mode or Run Mode) − [TF settings]
1
Set [Auto sensor detection] to [ON].
Note
If there are more than eight Sensors available for connection, use [Sensor List] to select the Sensors to connect.
Selecting the Sensors to Connect: p. 264
Registering the Sensors to Connect
You can set any of the Sensors for connection to the Touch Finder and register them.
(Run Mode) − [Sensor List]
1
Press any line and then press [Add].
2
Enter the IP address.
3
Press the IP address that you entered, and then press
[Comm. test] to confirm that connection is possible.
FQ2-S/CH User's Manual
FQ2-S4 FQ2-CH

Connecting to More Than One Sensor

263