Increasing Processing Speed; Editing The Model Regions And Measurement Region - Omron FQ2-S/CH Series User Manual

Increasing Processing Speed

The following two methods can be used to reduce processing time.
• Reduce the range in which a shape search II is performed for the model.
Changing the measurement region: p. 153
• Reduce the angle range setting.
Adjust the [Angle range] parameter to reduce the range in which a shape search II for the model is performed.
Setting the angle range: p. 160

Editing the Model Regions and Measurement Region

Changing the Model Regions
This section describes how to edit the model regions.
You can edit the model region in the same way as for a search region.
Changing the Model Registration Region to a Shape Other Than a Rectangle:
Important
If the model region is changed, perform teaching again.
p. 157
Changing the Measurement Region
The region within which the model is searched can be changed. You can edit the measurement region in the
same way as for a search region.
Changing the Measurement Region:
FQ2-S/CH User's Manual
Model registration region
Measurement region
(region that is searched for the model)
p. 153
Inspecting with the Shape Search II Inspection Item
p. 151
161