Toyota 1HD-FT Repair Manual page 146

ENGINE - FUEL SYSTEM
EG·133
(e) Using needle nose pliers. remove the connecting pin.
NOTICE: Be careful not to damage the connecting pin.
Tapa the tip of the plier•.
E. Remove No.2 SICS lever
(a) Remove the No.2 SICS lever. O-ring and washer
assembly from the governor cover.
(b) Disassemble these parts from the No.2 SICS lever. 0
-ring and washer assembly.
(1) O-ring
(2) Washer
5mm
Hexagon,--~~~
Wrench
FU2811
~
Voila BACS
wi BACS
(1 )
""~
F. Remove overflow screw
(a)
w/o BACS:
Remove the rubber cap and overflow screw.
(b)
wi
BACS:
Remove the overflow screw and gasket.
G. Remove full load set screw
17. CHECK FLYWEIGHT HOLDER THRUST
CLEARANCE
(See step 16 in injection pump assembly)
Thrust cl ••rance:
0.15 - 0.35
mm
(0.0059 - 0.0138
in.)
18. REMOVE GOVERNOR SHAFT AND FLYWEIGHT
HOLDER
(a) Remove the governor shaft lock nut by turning it
clockwise.
NOTICE: The governor shaft and lock nut have LH
threads.
(b) Using a 5 mm hexagon wrench. remove the governor
shaft. 0 - ring clockwise and remove these parts:
(1) Flyweight holder assembly
(2) No.1 flyweight washer
(3) Governor gear adjusting washer
HINT: Be careful not to drop the 2 washers into the
pump housing.