Toyota 1HD-FT Repair Manual page 9

IN
IN-6
INTRODUCTION - GENERAL REPAIR INSTRUCTIONS
9. Use of special service tools (SSn and special service
materials (SSM) may be required. depending on the
nature of the repair. Be sure to use SST and SSM
where specified and follow the proper work proce-
dure. A list of SST and SSM can be found in the
preparation part at the front of each section in this
manual.
Fu",
EQual Amperage
Rali~
10 )
10 )
10. When replacing fuses. be sure the new fuse has the
correct amperage rating. 00 NOT exceed the rating or
use one with a lower rating.
illustration Symbol Abbreviation
IE559-t
8£5517
tnSM
~ FUSE
..,
. .
~
MEDIUM CURRENT FUSE
~
HIGH CURRENT FUSE
~
FUSIBLE LINK
-R-
CIRCUIT BREAKER
..,..
FUSE
M.fUSE
H·FUSE
FL
CB
11. Care must be taken when jacking up and supporting
the vehicle. Be sure to lift and support the vehicle at
the proper locations.
(a) If the vehicle is to be jacked up only at the front
or rear end. be sure to block the wheels at the
opposite end in order to ensure safety.