Toyota 1HD-FT Repair Manual page 75

EG-62
ENGINE - ENGINE MECHANICAL
EG
(d) Install the collar to the rear exhaust manifold.
(e) Assemble the front and rear exhaust manifolds.
13. INSTALL EXHAUST MANIFOLD TO
TURBOCHARGER
(5•• step 2 in turbocharger installation in
Turbocherger Sy.tem)
14. INSTALL TURBOCHARGER AND EXHAUST
MANIFOLDS ASSEMBLY
(S•• step. 4. 5 and 8 to 9 in turbocharger
installation in Turbocherger System)
15. INSTALL WATER OUTLET
(a) Install a new gasket to the intake manifold.
(b) Connect the wate, bypass hose to the water outlet.
(e) Install the water outlet with the 2 nuts.
Torque: 19.8 N·m (200 kgt.em. , . ft·lbf)
16. INSTALL INTAKE MANIFOLD
(a) Install 2 new gaskets and the intake manifold with the
8 seal washers and 8 nuts. Uniformly tighten the nuts
in several passes.
Torque: 19.8 N·m {200 kgf·em, 14 ft·lbt)
(b)
wi
EGR System:
Connect the 3 vacuum hoses to the injection pump.
(e)
w/o
EGR System:
Connect these vacuum hoses:
• 2 vacuum hoses to injection pump
• Vacuum hose to
2
clamps on timing belt cover
17. INSTALL INJECTION PIPES
(See stepi 3 end 5 in injection nozzles installation in
Fuel SYltem)