Toyota 1HD-FT Repair Manual page 161

EG
EG·148
Europe
ENGINE - FUEL SYSTEM
19. INSTALL ADJUSTING LEVER SHAFT TO
GOVERNOR SHAFT
(a) Install these parts to the adjusting lever shaft.
(1) Washer
(2) New O-ring
(b) Install the adjusting lever shaft. washer and O-ring
assembly to the governor cover.
20. INSTALL GOVERNOR COVER
(a) Europe:
Install a new gasket to the groove of the governor
cover.
(b) Europe:
Connect the adjusting lever shaft to the governor link
and twist the shaft lightly_
(cl Australia:
Install the speed control spring to the adjusting shaft.
(d) Australia:
Install a new gasket to the groove of the governor
cover.
(e) Australia:
Install the damper spring and spring seat, and connect
the speed control spring to the spring seat.
115519
{fl Using a 5 mm hexagon wrench. install the governor
cover with the 4 bolts.
Torque: 8.3 N·m (85 kgf·cm. 74 In..tbf)
HINT: Use the bolt which is 35 mm (1.38 in.) length.
5mm
Hexagon
Wrench
(9) Install the idle speed adjusting screw and lock nut.
Torque: 6.9 N·m (70 kgf·cm. 61 in..lbfl