Purging The Module Configuration - Cisco Nexus 7706 Hardware Installation Manual

Purging the Module Configuration

ejector based shutdown, Ejector policy enabled.
switch#
switch# show module xbar 1
Xbar Ports
---
1
Xbar Sw
---
1
Xbar MAC-Address(es)
---
1
Chassis Ejector Support: Enabled
Ejector Status:
Top ejector OPEN, Bottom ejector OPEN, Module HW does not support ejector
based shutdown, Ejector policy disabled.
switch#
Purging the Module Configuration
You can clear the running configuration for an I/O slot that is not functioning by using the purge module
command in EXEC mode.
This command does not work on supervisor slots nor on any I/O slot that currently has a powered-up
Note
module.
Before You Begin
Verify that either the I/O slot is empty or the I/O module installed in the slot is powered down.
Clear the running configuration by using the purge module slot_number runnning-config command.
Example:
switch# purge module 4 running-config
For example, suppose you create an IP storage configuration with a 48-port 10/100/1000 Ethernet I/O module
in slot 3 of Switch A. This module uses an IP address. You decide to remove this I/O module and move it to
Switch B, and you no longer need the IP address. If you try to configure this unused IP address, you will
receive an error message that prevents you from proceeding with the configuration. In this case, you need to
enter the purge module 3 running-config command to clear the old configuration in Switch A before using
the IP address.
Cisco Nexus 7706 Hardware Installation Guide
64
Module-Type
----- ----------------------------------- ------------------ ------
0 Fabric Module 1
Hw
-------------- ------
NA 0.101
--------------------------------------
NA
Model Status
N7K-C7018-FAB-1 ok
Serial-Num
----------
JAF1225AGHJ
Managing the Switch
OL-31330-01