Cisco Nexus 7706 Hardware Installation Manual page 32

Installing the Chassis in a Two-Post Rack
Use two persons to push the chassis onto the bottom-support rails. Push the lower half of the front side of the chassis so
that the back side enters the rack first, and push until the chassis is halfway onto the rack (see the following figure).
Ensure that the chassis does not get caught on any of the expansion edges of the bottom-support rail.
Figure 8: Moving a Chassis onto a Rack or Cabinet
1 Push the sides of the lower half of the front side of
the chassis.
To adjust the placement of the chassis on the bottom-support rails, you can use the handles on the sides of the
Tip
chassis.
Step 5 If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level of the rails or no
more than 1/4 inch (0.6 cm) below the rails.
This action helps to prevent the bottom of the chassis from getting caught on the bottom expansion edges of the
bottom-support rails.
Cisco Nexus 7706 Hardware Installation Guide
22
2 Push the chassis into the rack until its mounting
bracket touches the vertical mounting rails on the
rack.
Installing the Switch Chassis
OL-31330-01