Table of Contents
Advertisement
Installing the Chassis on a Four-Post Rack or Cabinet
Step 6
Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come in contact with the
vertical mounting rails on the rack.
Step 7
Use seven M6 x 19 mm or 24 x 3/4-inch screws to attach each of the two vertical mounting brackets on the chassis to
the two vertical mounting rails on the rack (total of 14 screws). See Callout 2 in the following figure.
Figure 11: Attaching the Chassis to the Rack
1
Handles used to adjust the chassis
placement
Step 8
If you removed any fabric modules before moving the chassis, replace each one in the chassis as follows:
a) Holding the front of the fabric module (the side with the LEDs), turn the module so that the front side is vertical.
The top of the module has an alignment bracket running from the rear to the front. The electrical connectors
Note
will be at the bottom.
b) Align the rear of the fabric module to an open fabric slot and insert the bracket on top of the module into the track
at the top of the slot.
If there are only three fabric modules to install, install them in fabric slots 2, 4, and 6, and be sure that there
Note
are blank filler plates installed in the open slots.
c) Slide the module part way into the slot.
d) Press the ejector button on the front of the module, to release the levers from the front of the module.
e) Rotate the levers away from the front of the module and hold them while sliding the module all the way into the slot.
f) Simultaneously rotate both levers to the front of the module. They click when locked to the front of the module.
Step 9
If you removed any fan trays before moving the chassis, reinstall each one in the chassis as follows:
a) Holding each of the two handles on the fan tray with your two hands, align the fan tray to an open fan tray slot.
Cisco Nexus 7706 Hardware Installation Guide
28
2
Six M6 x 19 mm or 10-24 x 3/4 in. Phillips screws used to attach each
side bracket to a front mounting rail (use a total of 12 screws)
Installing the Switch Chassis
OL-31330-01
Hide quick links:
Advertisement
Table of Contents
