Cisco Nexus 7706 Hardware Installation Manual page 72

Displaying Information for the Installed Modules
I/O Module State
initializing
failure
ok
power-denied
active
HA-standby
Use the show module [slot_number] | [xbar slot_number] command in one of the following ways:
Option
show module
show module slot_number
Display information for all or specific modules.
Displaying Information for All Installed Modules
switch# show module
Mod Ports
--- -----
1 48
2 48
3 0
4 0
5 48
6 48
Mod Power-Status
--- ------------
2 powered-dn
Mod Sw
--- --------------
1 6.2(6)
3 6.2(6)
4 6.2(6)
5 6.2(6)
6 6.2(6)
Mod MAC-Address(es)
Cisco Nexus 7706 Hardware Installation Guide
62
Description
The diagnostics have completed successfully and the configuration is being
downloaded.
The switch detects a module failure upon initialization and automatically attempts to
power-cycle the module three times. After the third attempt, the module powers down.
The switch is ready to be configured.
The switch detects insufficient power for an I/O module to power up.
This module is the active supervisor module and the switch is ready to be configured.
The HA switchover mechanism is enabled on the standby supervisor module.
Description
Displays information for all of the installed modules.
Displays information for a supervisor or I/O module that you specify by its
slot number.
Module-Type
----------------------------------- ------------------ ----------
1/10 Gbps Ethernet Module
1/10 Gbps Ethernet Module
Supervisor Module-2
Supervisor Module-2
1/10 Gbps Ethernet Module
1/10 Gbps Ethernet Module
Reason
---------------------------
Configured Power down
Hw
------
1.0
1.0
1.0
1.0
0.203
Model Status
N77-F248XP-23E ok
N77-F248XP-23E ok
N77-SUP2E active *
N77-SUP2E ha-standby
N77-F248XP-23E ok
N77-F348XP-23 ok
Serial-Num
Managing the Switch
OL-31330-01