Purging The Module Configuration - Cisco Nexus 7702 Hardware Installation Manual

Managing the Switch
Displaying Information for All Installed Modules
switch# show module
Mod
---
1
2
Mod
---
1
2
Mod
---
1
2
Mod
---
1
2
* this terminal session
Displaying Information for a Specific Supervisor or I/O Module
switch# show module 1
Mod
---
1
Mod
---
1
Mod
---
1
Mod
---
1
Chassis Ejector Support: Enabled
Ejector Status:
Left ejector CLOSE, Right ejector CLOSE, Module HW does support
ejector based shutdown, Ejector policy enabled.
switch#

Purging the Module Configuration

You can clear the running configuration for an I/O slot that is not functioning by using the purge module
command in EXEC mode.
Note This command does not work on supervisor slots nor on any I/O slot that currently has a powered-up
module.
Ports Module-Type
----- ----------------------------------- ------------------ ----------
48 1/10 Gbps Ethernet Module
0 Supervisor Module-2
Sw Hw
--------------- ------
7.3(0)DX(1) 0.701
7.3(0)DX(1) 1.3
MAC-Address(es)
--------------------------------------
50-06-ab-91-05-a0 to 50-06-ab-91-05-d3
04-6c-9d-33-fb-07 to 04-6c-9d-33-fb-19
Online Diag Status
------------------
Pass
Pass
Ports Module-Type
----- --------------------------------- ---------------- ------
48 1/10 Gbps Ethernet Module
Sw Hw
-------------- ------
7.3(0)DX(1) 0.701
MAC-Address(es)
--------------------------------------
50-06-ab-91-05-a0 to 50-06-ab-91-05-d3
Online Diag Status
------------------
Pass
Purging the Module Configuration
Model Status
N77-M348XP-23L ok
N77-SUP2E active *
Serial-Num
----------
JAE194108S6
JAE193601AX
Model Status
N77-M348XP-23L ok
Serial-Num
----------
JAE194108S6
Cisco Nexus 7702 Hardware Installation Guide
51