Cisco Nexus 7706 Hardware Installation Manual page 95

Installing or Replacing Modules, Fan Trays, and Power Supplies
b) Grab both handles with both of your hands and pull the bottom of the fan tray out so that its connectors disconnect
from the chassis (see the following figure).
Figure 27: Removing a Fan Tray
1 Unscrew four captive screws until they are no
longer attached to the chassis.
c) After the connectors are free of the chassis connections, pull whole fan tray off the chassis.
d) Set the fan tray down on one of its covered sides only on an antistatic pad or inside an antistatic bag.
Caution Do not touch the electrical connectors on the back side and do not set the back side connectors on
anything—always set a fan tray down on a covered side to protect the connectors.
Step 2
If you need to open a fabric slot for the new fabric module, remove a fabric module as follows:
a) With your face at least 12 inches (30 cm) away from the front of the fabric module, press both ejector buttons on the
front of the module (see Callout 1 in the following figure).
OL-31330-01
Installing or Replacing a Fabric Module
2 Pull both handles to remove the module from the
chassis.
Cisco Nexus 7706 Hardware Installation Guide
85