Table of Contents
Advertisement
Installing the Switch Chassis
Use two persons to push the chassis onto the bottom-support rails. Push the lower half of the front side of the chassis so
that the back side enters the rack first, and push until the chassis is halfway onto the rack (see the following figure).
Ensure that the chassis does not get caught on any of the expansion edges of the bottom-support rail.
Figure 10: Moving a Chassis onto a Rack or Cabinet
1
Push the sides of the lower half of the front side of
the chassis.
2
Chassis mounting brackets.
Tip
To adjust the placement of the chassis on the bottom-support rails, you can use the handles on the sides of the
chassis.
Step 5
If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level of the rails or no
more than 1/4 inch (0.6 cm) below the rails.
This action helps to prevent the bottom of the chassis from getting caught on the bottom expansion edges of the
bottom-support rails.
OL-31330-01
Installing the Chassis on a Four-Post Rack or Cabinet
3
Rack vertical mounting rails.
Cisco Nexus 7706 Hardware Installation Guide
27
Hide quick links:
Advertisement
Table of Contents
