Cisco Nexus 7706 Hardware Installation Manual page 48

Attaching the Front Door to the Chassis
2 Door stop bracket
b) Secure the bracket to the hood by screwing in two captive screws on the bracket to the hood and tighten to each screw
to 8 in-lb (0.9 N·m) of torque.
Step 2 Attach the front door as follows:
a) Place the two rollers at the bottom of the front door on the two holders at the bottom of the right and left cable
management frames (see Callout 1 in the following figure).
Figure 18: Placing the Door on the Cable Management Frames
1 Place the two rollers on the bottom of the door on
the holders (one holder at the bottom of each cable
management side frame.
b) With the door resting on the holders, rotate the top of the door to the metal door-stop bracket installed at the bottom
of the top hood.
Magnets on the top of the door hold the door shut. If you need to lock the door in place, use the key that comes with
the door.
Cisco Nexus 7706 Hardware Installation Guide
38
2 Rotate the top of the door to the top hood until the
door is held in place magneticly.
Installing the Switch Chassis
OL-31330-01