Reports; Start-Up Report - Buderus Logamax plus Installation Instructions Manual

15 Reports

15.1 Start-up report

Enter your signature and the date after completing the start-up activities.
Start-up activities
1. Check for gas leaks
2. Fill the heating system
– Pre-pressure expansion vessel (refer to the installation
instructions for the expansion vessel)
– Heating system filling pressure
3. Fill the condensate trap with water
4. Write down the gas characteristics:
5. Bleed the gas supply valve
6. Check the air/flue gas connection
7. Checking the appliance configuration
8. Measure the gas inlet pressure (working pressure)
9. Check and adjust the gas/air ratio
10. Carry out a leakage test in operating conditions
11. Measure the flue gases CO emissions
12. Carry out a function test
- Measure the ionization current
12. Measure the pH-value
13. Boiler settings
14. Final activities
- Close the boiler door and the control panel
- Hand over
Confirming proper start-up
Logamax plus GB162-80 kW/100 kW - Subject to modifications resulting from technical improvements!
Page Measurement results
46
47
____________ psi
____________ psi
48
Heat input ____________ btu/ft³
Heat output ____________ btu/ft³
49
49
50
50 ____________ inch W.C.
52 ____________ inch W.C.
54
55 ____________ ppm
56
____________ μA
56
Fill in the record book
58
60
Remarks
Company stamp/signature/date
Reports 15
85