Konica Minolta bizhub C3850 User Manual page 46

1
4
From [Peer] on the [IPsec Settings] screen, click [Edit] and register peers of this machine.
% Up to 10 [Peer] can be registered.
Item
[Name]
[Set IP Address]
[Pre-Shared Key Text]
[Key-ID String]
5
From [Protocol Setting] on the [IPsec Settings] screen, click [Edit] and specify the protocol used for IP-
sec communication.
% In [Protocol Setting], up to 10 items can be registered.
Item
[Name]
[Protocol Identifica-
tion Setting]
[Port No.]
6
Click [Apply], and close the [IPsec Settings] screen.
7
In the Administrator mode, select [Security] - [IPsec] - [IPsec] - [General Settings], then configure the
following settings.
Item
[IPsec]
[Dead Peer Detection]
[Cookies]
[ICMP Pass]
[ICMPv6 Pass]
[Default Action]
1-38
Available operations in Administrator mode
Description
Enter a peer name (using up to 10 characters).
Select the method to specify the peer address. Specify the IP address of
the peer depending on the selected method.
Enter the Pre-Shared Key text to be shared with the peer (using ASCII
characters of up to 128 bytes).
To enter text in HEX code, select the [HEX Format] check box, then enter
the text.
Specify the same text as that for the peer.
Enter the Key-ID to be specified for the Pre-Shared Key (using ASCII char-
acters of up to 128 bytes).
Description
Enter the protocol name (using up to 10 characters).
Select a protocol used for IPsec communication.
If [TCP] or [UDP] has been selected in [Protocol Identification Setting],
specify the port number used for IPsec communication.
Description
Select whether or not to enable IPsec.
[Disable] is specified by default.
If no response can be confirmed from the peer in a certain period, the SA
with the peer is deleted.
Select a time that elapses before sending survival confirmation informa-
tion to the peer how has not responded.
[60] is specified by default.
Select whether or not to enable the defense using Cookies against denial-
of-service attacks.
[Disable] is specified by default.
Select whether or not to apply IPsec to the Internet Control Message Pro-
tocol (ICMP).
Select [Enable] to allow the ICMP packets to pass without applying IPsec
to the ICMP.
[Enable] is specified by default.
Select whether or not to apply IPsec to the Internet Control Message Pro-
tocol for IPv6 (ICMPv6).
Select [Enable] to allow the ICMPv6 packets to pass without applying IP-
sec to the ICMPv6.
[Enable] is specified by default.
Select an action to be taken if no settings meet the [IPsec Policy] while IP-
sec communication is enabled.
Select [Deny] to discard IP packets that do not meet the [IPsec Policy] set-
tings.
[Allow] is specified by default.
1.5
bizhub C3850/C3350