Konica Minolta bizhub C3850 User Manual page 109

2.9 Registering a destination
Settings
[Monotone]
[Separate Scan]
[Density]
[Background Remov-
al]
[Sharpness]
[Scan Size]
[E-mail Notification]
[Original Direction]
[2-Sided Binding Di-
rection]
[Special Original]
[Timer TX]
[Password TX]
[F-Code]
bizhub C3850/C3350
Description
Select whether or not to scan in gray scale or in black and white when an
original is scanned in black and white.
[Grayscale] is specified by default.
When there are too many original sheets that cannot be loaded into the
ADF at the same time, if you want to load them in several batches and
handle them as one job, select [On].
[Off] is specified by default.
Adjust the density (Dark or Light) to scan the original.
[0] is specified by default.
Adjust the density of the background area when printing originals with
colored background (newspaper, recycled paper, etc.) or originals that are
so thin that text or images on the back would be scanned.
[0] is specified by default.
Sharpen the edges of images to improve legibility. Smoothen the rough
contours of images or sharpen blurred images.
[0] is specified by default.
Specify the size of the original.
Select [On] to use the E-mail notification function. Also, enter the destina-
tion E-mail address.
[Off] is specified by default.
When scanning a double-sided original, you can specify the original load-
ing direction so that the vertical direction is set correctly after scanning.
[Left] is specified by default.
Select the biding position of original when scanning both sides of the orig-
inal.
[Auto] is specified by default.
Select [Long Original] to scan a long original.
[Normal] is specified by default.
To set a time to start fax transmission, select [On]. Also, specify when to
start fax transmission.
[Off] is specified by default.
To send fax with a password to a destination for which fax destinations
are restricted by passwords (Closed Network RX enabled), select [On]. Al-
so, enter the password.
[Off] is specified by default.
Select [Enable] to enable F-Code TX. Also enter [SUB Address] and [Pass-
word].
[Disable] is specified by default.
2
2-31