Device; General; Alarm - Digimerge DH230 Series Instruction Manual

DEVICE

Configure Alarm Out, Alarm Buzzer,
and alarm input settings.

GENERAL

The GENERAL tab allows you to configure Post
Recording time, Audio recording, Key Tone
(key "beeps"), and Key Sensitivity.
1. Configure the following in the General tab:
• DISPLAY: Select the output resolution.
• AUDIO RECORD: Select ON or OFF to
enable or disable audio recording.
• KEYPAD MODEL: Select the PTZ keyboard
model and baud rate.
• EXTENDED DEVICE: Select the desired
device
• PTZ EVENT: Select the duration of a PTZ
event.
• ALARM OUT: Select the duration of an
alarm out event.
2. Click ENTER to save your settings.

ALARM

The ALARM tab allows you to configure the
system Alarm Buzzer and Alarm Input type on
each channel (i.e. N.O and N.C (normally open
and normally closed) settings)).
1. Configure the following in the Alarm tab:
• INPUT: Select the alarm type connected to
the particular channel. Select from N.O or
N.C (Normally Open, or Normally Closed).
• OUTPUT: Select N.O (Normally Open) or
N.C (Normally Closed). Under INACTIVE,
select the event type (Manual or Event).
• BUZZER:Select ON/OFF. Under INACTIVE,
select the event type (Manual or Event).
• CONTROL: Turn the OUTPUT/ BUZZER on
or off. To enable the ON button , under
INACTIVE select MANUAL.
2. Click ENTER to save your settings.
Using the Main Menu
53