Configuring Post Event Action Tab; Setting Up Post Event Actions On A No/Nc Device - Digimerge DH230 Series Instruction Manual

Configuring Post Event Action Tab

The Post Event Action tab allows your system to alert you when an alarm event triggers the DVR.
For example, when the system detects motion from an input device, the computer speakers plays
a sound to alert you. Or, you can have the CMS-DH software alert you with a pop-up window when
motion is detected.

Setting up Post Event Actions on a NO/NC Device

Prerequisites (If setting up NO/NC Devices)
• Connect the input device into the alarm block in the rear panel of the DVR.
• Ensure you have the correct settings for the device (N/O , N/C), and that you have correctly
configured the settings in the DVR menu.
• Ensure the DVRs are online.
To configure the Post Event Action tab:
1. Expand the menu tree under the desired DVR that you wish to configure.
2. Under Alarm Input, right-click the number block that your device is connected into.
3. Click Post Event Action.
Right-click on
the device you
wish to
configure
4. Configure the following:
• Events: Select Alarm Input ON or Alarm Input OFF
• Command: Select from Play Sound or None.
CMS-DH Central Management Software
97