Appendix H: Connecting Motion / Alarm Devices - Digimerge DH230 Series Instruction Manual

Appendix H: Connecting Motion / Alarm Devices

APPENDIX H: CONNECTING MOTION / ALARM
You can enable motion detection and alarm control from the Main Menu. You can also connect
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use
a motion detector or sensor to send a signal to the system to begin camera viewing and recording
on the matching camera channel (when enabled in the Menu).
To connect an external alarm sensor (ALARM INPUT) to the system:
1. Connect the Signal Cable to the desired
2. Connect the Ground cable to the
3. Open the MAIN MENU and select
4. Select the corresponding alarm channel and select
5. Select (Normally closed) or
N.C.
6. Press the button to save your settings.
ENTER
*16-channel, DH230 model shown.
162
DEVICES
port
Ground port (G)
DEVICE>ALARM
(normally open) depending on your alarm/sensor setup.
N.O.
DH230
ALARM or SENSOR
(Not Included)
in the alarm block.
in the alarm block.
.
.
INPUT
DH250 Alarm Block
Ground