Konica Minolta bizhub C450 Copy Operations page 519

Utility
8
Check that the distance from the start-
ing print position of the test pattern to
the left edge of the paper (c) is 3 mm
(± 0.5 mm).
– If the distance is less than 2.5 mm,
touch [+] to increase the adjust-
ment (between 0.2 mm and 3.0
mm).
– If the distance is more than 3.5 mm,
touch [–] to reduce the adjustment
(between –0.2 mm and –3.0 mm).
– If the distance is between 2.5 and 3.5 mm, skip to step 14.
– Each time [+] or [–] is touched, the value is increased or decreased
by one increment.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Adjust the distance from the starting print position of the test pattern to
the edge of the paper.
– Check that the distance has been adjusted to between 2.5 and 3.5
mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different paper drawer, return to
step 6.
11
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
C450
c
c: 3.0 mm
± 0.5 mm
12
12-47