IBM eServer xSeries 235 Type 8671 Option Installation Manual page 72

60
IBM xSeries 235 Type 8671: Option Installation Guide
6. Locate the battery (connector BH1) on the system board.
VRM 2 (J1)
Microprocessor 2
(U9)
Microprocessor 1
(U13)
VRM 1 (J17)
Remote Supervisor
Adapter (J27)
PCI slot 1 32-bit 5.0 V
(J32)
PCI-X slot 2 64-bit 3.3 V
(J36)
PCI-X slot 3 64-bit 3.3 V
(J38)
PCI-X slot 4 64-bit 3.3 V
(J41)
PCI-X slot 5 64-bit 3.3 V
133 MHz hot-plug (J43)
PCI-X slot 6 64-bit 3.3 V
133 MHz hot-plug (J45)
7. Remove the battery:
a. Use one finger to press the top of the battery clip away from the battery
until the battery releases upward from the socket.
b. Lift and remove the battery from the socket.
8. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
9. Replace the plastic shield covering the bottom portion of the system board.
DIMM 1 (J7)
DIMM 2 (J9)
DIMM 3 (J11)
DIMM 4 (J12)
DIMM 5 (J14)
DIMM 6 (J15)
Battery (BH1)