Replacing A Hot-Swap Power Supply - IBM eServer xSeries 235 Type 8671 Option Installation Manual

Replacing a hot-swap power supply

Some models of your server come with two hot-swap power supplies. You do not
need to turn off the server to replace a hot-swap power supply, but you must
replace only one power supply at a time.
I/O cable-restraint
bracket
Hot-swap
power supply 2
Release latch
Handle
AC power LED
DC power LED
Hot-swap
power supply 1
Power-cord
restraint bracket
Before you continue with the power-supply replacement procedure, review the
following.
Note: Two cable-restraint brackets are on the rear of the tower model servers. After
you connect the cables to the selected devices, you can use these
cable-restraint brackets to manage the cable routing. Route the power cords
through the power-cord restraint bracket on the bottom. Route the remaining
cables (for example, the cables that are connected to the I/O ports) through
the I/O cable-restraint bracket on the top.
Chapter 2. Installing options
49